Quaz
09-10-2002, 02:45 PM
I can't seem to figure this out. The client keeps timing out every 60 seconds. :confused:
I'm trying to create a stable connection between a Linksys WUSB11 adapter and a Cisco 340 AP. The two are located in seperate houses across the street with a line-of-sight connection which is about 250ft apart. The only things between them is glass and a couple of tree branches. The signal strength averages 45% and maintains a low level connection with the AP, but will constantly generate preamble errors. I've tried both short and long preambles and adjusted the beacon rate. Anyway, the client will systematically times out every 60 seconds on the dot. Take a look and provide any feedback. Thanks!!
I'm trying to create a stable connection between a Linksys WUSB11 adapter and a Cisco 340 AP. The two are located in seperate houses across the street with a line-of-sight connection which is about 250ft apart. The only things between them is glass and a couple of tree branches. The signal strength averages 45% and maintains a low level connection with the AP, but will constantly generate preamble errors. I've tried both short and long preambles and adjusted the beacon rate. Anyway, the client will systematically times out every 60 seconds on the dot. Take a look and provide any feedback. Thanks!!