Cisco 350 Access Points

[tdulle]

#1, I am very illiterate concerning wireless.

I am trying to connect a Dynamic Analyzer (Or38) to a Lapto using 2 Cisco AP-350 Acess Points. When I first recieved the AP's, I set up the IP address for each AP, hooked them up and they worked right off. Then when I tried to use the Or38 in the field, the AP's wouldn't connect up to each other. Using a wireless card, I could connect to each AP, but couldn't get anything through the AP's.

After contacting Cisco tech support, the tech said the AP's couldn't be used together, that I need one AP and a bridge. I really don't understand this, seeing as how I used a AP-300 in the past in this same configuration, and also it worked on the bench.

Hope someone can help me!

Todd

[MC_MAC_MX]

Did you tryconfiguring one of the Ap as "Root Access Point" and the other one as "Repeater" ?, that works with cisco 1200

GL

[tdulle]

I'm going to try that today. Its not exactly what I wanted, because repeater disables the wired ethernet port.

I'll let you know if it works tho.

Thanks for the reply!
Todd