rbjones
07-05-2003, 03:17 PM
Greetings, I am in the process of setting up a WISP/Hotspot company and in great need of tapping the knowledge base here in this forum. Here is my setup.
I installed and configured a W2K server with IAS, and assorted WAP's (Orinoco AP-2500's and 2000's) The WAP's are tied into and communicating with my MS IAS server. Everything appears to work as far as the authentication and timeout issues but two things I would like to do which I cannot find and hint of how to limit anywhere on the Internet or user groups. I would like to do the following through the use of Mictosoft's IAS server.
1. Limit the user to only one dial in session per request. The user ID is limited to only one logon, therefore preventing someone from using their ID.
2. Set Hotspot user ID's for a "One Time Use". Whereas once they are issued a user ID and their timer counts down to 0 or session terminates they cannot log back on and be reauthenticated.
I am not sure if this is controlled via a vendor specific attribute or perhaps another setting, but I would be indebted... thanks in advance.
rj
I installed and configured a W2K server with IAS, and assorted WAP's (Orinoco AP-2500's and 2000's) The WAP's are tied into and communicating with my MS IAS server. Everything appears to work as far as the authentication and timeout issues but two things I would like to do which I cannot find and hint of how to limit anywhere on the Internet or user groups. I would like to do the following through the use of Mictosoft's IAS server.
1. Limit the user to only one dial in session per request. The user ID is limited to only one logon, therefore preventing someone from using their ID.
2. Set Hotspot user ID's for a "One Time Use". Whereas once they are issued a user ID and their timer counts down to 0 or session terminates they cannot log back on and be reauthenticated.
I am not sure if this is controlled via a vendor specific attribute or perhaps another setting, but I would be indebted... thanks in advance.
rj